METACENTRE system controller

Does the Metacentre Master work with multiple VSD compressors?
If you connected multiple VSD compressors on the Metacentre Master ( XC/SX/P4). The Master controller will only regulated 1 VSD compressor between his m...
Mon, 26 Nov, 2018 at 4:39 PM
I'm installing a Metacentre system controller, where's the best place to locate the control pressure sensor(s)?
The system pressure sensor (P) must be located in a position that will continuously experience pressure that is common to all compressors. Refer to Metacen...
Mon, 12 Dec, 2016 at 10:32 AM
I've installed and commissioned the Metacentre system controller but compressors are loading and unloading erratically. What's happening?
Metacentre system controllers load and unload a group of air compressors to maintain the configured target system pressure measured at the control pressure ...
Mon, 12 Dec, 2016 at 10:33 AM
I've installed my Metacentre system controller and accessories, how do I approach commissioning?
Review our pre-commissioning check list. Review the Technical Manual for the product your commissioning (can be downloaded from the download centre). Obtain...
Mon, 12 Dec, 2016 at 10:34 AM
The BLUE 'Available' LED(s) on the Metacentre system controller's fascia are flashing, what does this mean?
Review the LED diagnostics page of the products Technical Manual to establish the flash frequency.
Mon, 12 Dec, 2016 at 10:35 AM
The BLUE 'Available' LED(s) on the Metacentre fascia are flashing fast but the compressor is available and ready to start. What's wrong?
Check menu C03 of Metacentre system controller for accurate configuration (I-485, V-485, iPCB) For I-485 or V-485, ensure the respective compressor controll...
Mon, 12 Dec, 2016 at 10:35 AM