I'm installing a Metacentre system controller, where's the best place to locate the control pressure sensor(s)?
The system pressure sensor (P) must be located in a position that will continuously experience pressure that is common to all compressors. Refer to Metacentre system controller Technical Manual for further guidance.
Related Articles
Metacentre Sullair WS Gateway: Compressor Connectivity Products Manual
This is the current manual that supports Metacentre Sullair SW Gateway. It is based on the 'G1SULLWS_E08' software edition. This gateway interconnects Metacentre Master Controllers with Sullair SW controllers. See attachments tab to download. Page ...I've installed and commissioned the Metacentre system controller but compressors are loading and unloading erratically. What's happening?
Metacentre system controllers load and unload a group of air compressors to maintain the configured target system pressure measured at the control pressure sensor. Site specific factors such as 'insufficient storage' or 'significant instantaneous ...Metacentre (Compair/GardnerDenver) Gateway: Compressor Connectivity Products Manual
This is the current manual that supports Metacentre CompAir/Gardner Denver Gateway. See attachments tab to download. A full compatibility matrix is available at the end of the manual. It lists which controllers are compatible with what gateways. ...Metacentre VSD - R "mA" Box: Compressor Connectivity Products Manual
This is the current manual that supports Metacentre VSD-R "mA" Box (retrofit solution). See attachments tab to download. The Di3, Di4 and Di5 pin assignments on the 'Compressor Connections' wiring diagram, on manual p.38 is not correct. The pin ...Metacentre VSD mA kit: Compressor Connectivity Products Manual
This is the current Technical Manual (ref. MANY0521A) that supports Metacentre VSD mA products. This manual is available in following languages : English (GB) German (DE) French (FR) Russian (RU) See attachments tab to download.