Input Output Configuration

Input Output Configuration


The metacentre Core has 2 digital inputs and 1 digital output.
This page allows to configure what the inputs and outputs are used for.

DI1 used as Remote Start/Stop
Options:
• Enabled
• Disabled
Supposing the is set "Enabled", when the level on the DI1 goes high, the Metacentre Core is Started, when DI1 goes low, it is stopped.
When "Disabled", the Metacentre Core does not process the input.
 
DI2 used as Table trigger
Options:
• Disabled
• Table 1
• Table 2
• …
• Table 6
When this parameter is not set "Disabled" (hence to one of the Tables) and the level on DI2 is high, the selected table will be in use, overriding Schedule selection of a Table.
When DI2 level is low, the Table is selected by the Schedule.
 
Functionality of relay R1
Options:
• System ON 
• Any System Fault
• Any Compressor fault
• Insufficient Capacity
• Low Pressure Alarm
• High Pressure Alarm
When the selected state is detected, R1 will close.

    • Related Articles

    • Core Drive+ Configuration

      Knowledge of VSD compressor regulation methods, experience working with compressor control systems and basic principle knowledge of compressed air systems is required to be able to successfully install and commission a Metacentre Core Drive+ product. ...

    • VSD Output Monitoring kits manual

      Y02CM31 & CY02CM14

    • Metacentre VSD output monitoring kits: Compressor Connectivity Products Manual

      This is the current manual that supports Metacentre output monitoring products.   This manual is available in following languages :  English (GB) Chinese (ZH) See attachments tab to download. 

    • Core Link+ Configuration

      Using this page you set up a Metacentre Core Link+ The Configuration Wizard will automatically take you through all Link+ devices in the installation, setting these up one by one. On the top of the page, you are informed about the Address and the ...

    • Control Configuration

      This page hosts the following settings Stop Control Function: Determines if and how the Metacentre Core maintains control of the compressors when it is stopped. • Return pressure control to compressors • Maintain control and continuously hold all ...

      Customer Effort & Happiness Survey