Sequence Rotation Configuration
A "Sequence Rotation" event can be automatically triggered on a regular basis, using a pre-determined interval, a specific time each day, or a set day and time each week.
Mode can be:
- Off - No rotation event defined
- Interval
The Rotation event takes place a set number of times per day.
The number of times can be set in the range 1 (every 24 hours) .. 96 (every 15 minutes)
The first automated rotation event each day will occur at 00:00 hrs and then every set rotation interval time throughout the day - Time of each day
The Rotation event takes place at set time in the day (using "HH" and "MM") - Day and Time of each week
The Rotation event takes place at set time in the set day(s) in the week (using "HH" and "MM" and "Day")
The access to the fields in the user interface automatically adapts to the selected Mode.
Related Articles
Core Link+ Configuration
Using this page you set up a Metacentre Core Link+ The Configuration Wizard will automatically take you through all Link+ devices in the installation, setting these up one by one. On the top of the page, you are informed about the Address and the ...Core Drive+ Configuration
Knowledge of VSD compressor regulation methods, experience working with compressor control systems and basic principle knowledge of compressed air systems is required to be able to successfully install and commission a Metacentre Core Drive+ product. ...Input Output Configuration
The metacentre Core has 2 digital inputs and 1 digital output. This page allows to configure what the inputs and outputs are used for. DI1 used as Remote Start/Stop Options: • Enabled • Disabled Supposing the is set "Enabled", when the level on the ...Control Configuration
This page hosts the following settings Stop Control Function: Determines if and how the Metacentre Core maintains control of the compressors when it is stopped. • Return pressure control to compressors • Maintain control and continuously hold all ...Metacentre SX (User): System Controller Manual
This is the current User Manual (ref. MANY0736A) that supports Metacentre SX products. This manual is available in the English language. See attachments tab to download.