System Parameters
On this page, essential system parameters are set.
Installation name: Provide a name for the Metacentre Core installation. This name will appear on User interface pages and on the reports.
Number of compressors: the amount of compressor in the installation (1 .. 6)
Units: Metric (bar, m3/min, °C) or Imperial (psi, cfm, °F) to be selected. These units will be used by default throughout the user interface.
Date / time: Fill in the current date and time. This can later be adjusted on the dashboard if needed.
Timezone: Set the timezone where the system is located using the drop down selector.
Related Articles
Asset Parameters
This page provides the key parameters of the compressor assets in the system. In order to have the compressor system operate at optimum efficiency it is essential that these parameters are filled in precisely. Name For each Compressor Asset a name ...System Pressure Parameters
Minimum Pressure level alarm: A Pressure level which will trigger an alarm when the System Pressure drops below this level. This value is stored in Table 1. Target system pressure: The primary objective of the Metacentre Core is to control the ...Sensor Parameters
Using this page, the Sensor parameters are set. Second Pressure sensor: Select if a second pressure sensor is used or not. When in use, Differential Pressure will be displayed on the dashboard and Differential Pressure Level alarm can be used. A ...Metacentre P4: System Controller Manual
This is the current Technical Manual (ref. MANY0706A) that supports Metacentre P4 products. This manual is only available in the English language. See attachments to download.Metacentre SX: System Controller Manual
This is the current Technical Manual (ref. MANY0707A) that supports Metacentre SX products. This manual is available in the english language. See attachments tab to download.