Recent Articles
CORE Compatibility & Supported Devices
Using the Metacentre CORE with Link+ and Drive+ Modules: Metacentre CORE works directly with Link+ and Drive+ compressor interface modules CORE's Setup Wizard configures all connected Link+ and Drive+ modules (addresses, parameters, and full setup) ...
Explanation of Icons
When you power up your Core for the very first time — after completing installation on your compressors and piping — you’ll be greeted with the startup screen. From here, you’ll see two options: Run Setup Wizard Go to Dashboard Since this is the ...
CORE User Roles & Access Rights Overview
When setting up and operating a Metacentre CORE system, different users need different levels of access. For example, an installer or technician may require full administrative control during commissioning, while an operator or supervisor may only ...
Getting Started with CORE: Setup Wizard or Dashboard
When you first power up your CORE controller, you’ll see a landing page with two options: Run Setup Wizard Continue to Dashboard 1. Run Setup Wizard Choose this if you are commissioning a system or need to configure connected modules Guided, ...
Cable Routing and Electromagnetic Interference (EMI) Guidelines
RS485 data communications, ethernet communications and other low voltage signals can be subject to electrical interference. This potential can result in intermittent malfunction or anomaly that is difficult to diagnose. To avoid this possibility, ...